A #FAQ about #gypsum #plaster. Apparently #gelatin was the traditional material for molding plaster! Lots of great tips, including the crucial, “Do not rinse plaster off in a sink.”
on 02015-08-15#paper on #gelcasting #alumina and zirconia #ceramics #materials with #gelatin and polyethylene spheres to add porosity. Presumably you could use paraffin spheres too, which would be cheaper and maybe improve thixotropy. Something somewhat hydrophilic, not easily water-soluble, and burnable-out might work better still. (Lecithin?)
on 02015-08-15you can use #gelatin for #casting plaster and similar #materials instead of silicone? For some reason the author mixed 2 parts gelatin, 1 part honey, 2 parts glycerin, 1 part water, and for a mold release, cornstarch or talcum powder.
on 02015-08-15Galip Sarper Koçlar’s master’s thesis #paper on #gelcasting of #alumina #ceramics #materials with #gelatin and #carrageenan gum. He got best results with 5% by weight gelatin, or 1.7% by weight carrageenan, which resulted in significantly lower fired hardness but higher fired compressive strength than the gelatin, and all his trials were with 47–53% alumina, which reached 95.8% after firing at 1550°, and a bit of Dolapix dispersant. 17.5% linear shrinkage. In English, not Turkish, although it’s kind of broken English. The introduction has the best #survey of gelcasting I’ve found so far. Apparently #acrylamide (and, I guess, other similar binders) needs 30–60 minutes to gel in the mold. He also mentions existing “natural gelcasting” processes for technical ceramics using “starch, ovalbumin, chitosan, alginades [sic; should be #alginate], #gelatin, carragenan [sic] gum and [sic] etc.”, and agarose, with the disadvantage being lower green strength.
on 02015-08-15Galip Sarper Koçlar’s master’s thesis #paper on #gelcasting of #alumina #ceramics #materials with #gelatin and #carrageenan gum. He got best results with 5% by weight gelatin, or 1.7% by weight carrageenan, which resulted in significantly lower fired hardness but higher fired compressive strength than the gelatin, and all his trials were with 47–53% alumina, which reached 95.8% after firing at 1550°, and a bit of Dolapix dispersant. 17.5% linear shrinkage. In English, not Turkish, although it’s kind of broken English. The introduction has the best #survey of gelcasting I’ve found so far. Apparently #acrylamide (and, I guess, other similar binders) needs 30–60 minutes to gel in the mold. He also mentions existing “natural gelcasting” processes for technical ceramics using “starch, ovalbumin, chitosan, alginades [sic; should be #alginate], #gelatin, carragenan [sic] gum and [sic] etc.”, and agarose, with the disadvantage being lower green strength.
on 02015-08-15